Skip to content

Serving the United States

DesertlineHeating & Air

Heating · Reno, NV

Furnace Repair in Reno

Most furnace no-heat calls are a dirty flame sensor, a failed hot surface igniter, a tripped limit or pressure switch, or a clogged filter. A tech reads the board's error code, tests each safety device, and checks for carbon monoxide before handing it back.

  • Same-day appointments when available
  • Licensed HVAC contractors
  • Written price before any repair
Glowing heating element inside a heater

Reno

Furnace Repair in Reno: what's different

Reno furnaces run for months each winter, so inducer motors, igniters and flame sensors wear out more often than in Southern Nevada. High-efficiency furnaces also fail when condensate lines freeze outside on cold nights.

Older homes in the Old Southwest and Midtown can have gravity furnaces, floor furnaces or boilers that need techs who still work on that equipment.

Reno also sits at about 4,500 feet, so furnaces need correct gas pressure and combustion settings for altitude. A furnace that keeps locking out on cold nights should have its vent, intake and condensate trap checked before parts are replaced, and every repair should end with a carbon monoxide reading.

Reno climate

Winter nights regularly fall below freezing, with inversions trapping cold air in the valley. Summers reach the upper 90s and low 100s, and wildfire smoke from California and Nevada fires often affects air quality.

Symptoms

Signs you need furnace repair

  • Cold air from the vents in heat mode
  • Burners light then shut off after a few seconds
  • Blinking LED code on the control board

Process

How the visit works

  1. 1

    Read the fault code

  2. 2

    Test ignition and safeties

  3. 3

    Combustion and CO check

  4. 4

    Repair and run test

Cost factors, safe DIY checks and equipment details are in the full furnace repair guide.

FAQ

Furnace Repair questions

Why did my high-efficiency furnace stop on a cold Reno night?+

A frozen or clogged condensate drain is a common cause. The pressure switch senses water backing up and shuts the furnace off.

Also available nearby

Furnace Repair overview · All HVAC services in Reno

Need heating or cooling help now?

Call to be connected with a licensed HVAC contractor serving your ZIP code, or send a request online.

Call nowRequest